MSFS - Boeing 787-10
Discuss this Profile on Discord
See You Have Control for info on modding aircraft profiles.
Changelog
2025-07-07 - v2
- Improvements to Baro STD Mode
- Range push CTR added to FS2020 (previously FS2024 only)
Pilot Notes
The MobiFlight setting Automatically perform Retrigger Action with Run Mode should be disabled when using this profile. Failure to do so causes unwanted commands when the profile is Run.
Flight Director & Autopilot
The aircraft only has one Flight Director system (both buttons drive the same system).
FD2 toggle switch and LED are available for reassignment to another function.
The same applies to CMD B.
TOGA
TOGA is commanded when N1 THR is pushed for 0.5 seconds.
Heading Select
This profile uses Heading Select rather than Heading Hold.
EFIS Controls
EFIS Modes are changed by using the virtual buttons at the top of the MFD.
These cannot be assigned to hardware. Therefore, the EFIS Map Mode buttons on the Circuit Avionics Autopilot are available for reassignment.
EFIS Range is working as intended.
Push the Range knob to Center the display.
BARO and MINS
BARO and MINS function as on the real aircraft. Rotate the knob to adjust. Push BARO for Standard pressure. Push MINS to reset the minimums.
Speed / Altitude Intervene
Push the IAS knob, as on the real aircraft.
Push the ALT KNOB, as on the real aircraft.
Altitude Increments (100 / 1000ft)
LONG PUSH of the ALT KNOB will toggle AUTO / 1000 ft increments. By default this is 1,000ft so you will have to adjust it if your initial altitude is e.g. 6,500ft.
